The PDI Post Delivery Inspection & Set Up Brought to you by, The "Big Guy"
What supplies might I need for the PDI? Partial supply list as suggested by Steve H. from our discussion board Battery Charger - no more than 2Amp, preferably a float charger. Air Compressor/Foot Pump - good to have on hand at all times. Check pressure on COLD tires only. Gasoline Can/Gas - one gallon plastic can filled with gas. Oil drain pan - any type will do, but the sealable ones are best. Always dispose of fluids properly! Oil - 5W-30 weight, or straight 30 weight for break in. Gear Oil - 75W 90, 80W 90 or any good synthetic gear oil. Anti-Freeze - Formulated for Aluminum engines, 50% anti freeze, 50% water. Flashlight - to look inside the gas tank. Metric socket set - basic set, 8, 9, 10mm are the most common sizes used. Pliers Rubber mallet Phillips head screwdrivers Locktite - blue Silicone - commercial or outdoor grade. Ziplock Bags Black Rustoleum Paint & Sandpaper Vacuum Lines Fuel lines - snip off a piece of each to bring to the auto parts store for the right inside diameter. Tire pressure gage Back to the PDI link   Now Get Out and PDI!
Photos and information used in this tutorial were gathered from The Louisiana Powerscooters Foundation and The ScootDawg Forum - credits and thank you to both discussion boards and their wonderful users!

The procedures described herein are the opinions of the "Big Guy" from Powerscooters.org
This publication is copywrite © 2007-2008, LPSF and may not reproduced or redistributed without
permission from the author. You can write to the "Big Guy" here and ask for permission.
Under NO circumstances shall this publication be used for commercial purposes or sold for profit.
Some of the procedures described within are dangerous, and should always be performed while
the scooter in on the center-stand. The LPSF, Powerscooters.org, and or the "Big Guy" take
no responsibility whatsoever for damage to your person or scooter while performing the PDI as
described in this procedure.